What is inside a mobile tyre van
A proper mobile tyre van is more than a jack and a compressor. Ours carry kit that lets the technician demount a tyre from the rim, inspect the inside, fit a new one and balance the wheel to the gram. That is the difference between a roadside plug and a workshop-standard repair.
- Tyre changer with a bead-protection arm for alloy and low-profile rims
- Computerised wheel balancer and a full set of stick-on and clip weights
- Compressor plus nitrogen supply
- Trolley jack, axle stands and wheel chocks
- Plugs, inside patches, valves, TPMS valve kits and a TPMS reset tool
- Torque wrench for wheel nuts, set to your car's specification
Jobs done on site
Almost every tyre job can be done in a car park. We fix punctures, swap the spare, fit and balance new tyres, rotate tyres front to rear, replace valves, fit TPMS sensors, top up with nitrogen and do a full tyre inspection. A set of four new tyres takes about an hour on site, slightly longer for 20-inch-plus or run-flat wheels.
We torque wheel nuts with a calibrated wrench rather than an impact gun alone. Over-tightened nuts warp brake discs and make the next roadside wheel change almost impossible with the car's own wrench.
Prices
| Service | Price |
|---|---|
| Mobile puncture repair call-outIncl. one repair; night +AED 50 | AED 99–149 |
| Tyre fitting (per tyre)17"+ / run-flat AED 50–80 | AED 30–45 |
| Wheel balancing | AED 25 per wheel |
| Tyre rotation | AED 60–80 |
| TPMS sensorFitted incl. programming | AED 220–450 |
Prices in AED, including VAT. Final price confirmed before work starts.
What a mobile van cannot do
Wheel alignment needs a level floor and a fixed camera rig, so it is workshop-only. The same applies to straightening a bent rim, which needs a hydraulic press and heat. We will tell you if we see uneven wear that points to alignment, and book you into Al Quoz rather than pretend a van can fix it.
Some sizes also need ordering. If you want a particular pattern in 22 inches, we confirm stock before the van sets off.
What we need from you on site
A flat surface, room on one side of the car to work, and access for the van within about 20 metres. Most villa driveways, office car parks and basements are fine. Mall basements and some towers require a gate pass, and a few low basements have under 2.1 m clearance; tell us and we bring the wheel up to street level if needed.
For locking wheel nuts, keep the key adapter ready, usually in the boot or glovebox. Without it, removing the wheel takes a lot longer.
Coverage and timing
Vans work across Dubai, Sharjah and Abu Dhabi, with Ajman on request. Puncture and flat-tyre call-outs run 24/7, with an AED 50 supplement between 22:00 and 06:00. Planned tyre fittings are booked in slots. If you are at home and want new tyres fitted, see tyre change at home; for an emergency, see roadside tyre assistance.
A typical day for one of our vans
A van usually starts with booked jobs: a set of four tyres fitted in an office car park in Business Bay, a TPMS sensor replaced at a villa in Al Barsha, a rotation for a company car in Al Quoz. Between those, the dispatcher slots in urgent calls, such as a nail puncture in a JLT basement or a flat on the Al Khail Road shoulder. That mix is why ETAs vary: a van that has just started fitting four 20-inch tyres will be busy for an hour, while one that has finished a repair may be ten minutes away.
Late afternoon brings the heat-related calls. Tyres that ran under-inflated all day fail on the drive home, and cars parked in open lots develop slow leaks as valves and beads expand and contract. In the evening and overnight, fewer vans are on duty and the work is mostly punctures and spare fitting.
Whatever the time, the routine on site is the same: chock the wheels, lift on the correct jacking point, check the tyre inside and out, do the work, torque the nuts, set the pressure from the placard and show you the result. Planned work is easiest to book in the morning. See tyre rotation for a job worth combining with any visit.
Services on this page
Tyre Change
Swapping wheels and tyres: spare on, second set on, or your own tyres mounted onto your rims, done properly with torque settings and a pressure check.
From AED 60Puncture Repair
A permanent puncture repair with the tyre removed and inspected inside, using a plug-patch where the damage is in the safe repair zone of the tread.
AED 35–50 per tyreWheel Balancing
Dynamic computer balancing that corrects weight differences in each tyre and rim, removing vibration and uneven wear.
AED 25 per wheelTyre Rotation
Moving tyres between positions in the correct pattern for your car, so they wear evenly and last longer, with a tread and pressure check included.
AED 60–80Frequently asked questions
Is mobile tyre repair as good as a workshop repair?
With the right kit, yes. Our vans can demount the tyre and fit an inside patch-plug, the same repair we do in the bay.
Can a mobile van balance my wheels?
Yes. Every van carries a computerised wheel balancer. Balancing costs AED 25 per wheel and is included when you buy tyres.
Can you do wheel alignment at my home?
No. Alignment needs a level floor and a fixed rig, so it is done at our Al Quoz workshop.
Do you need electricity or water at my location?
No. The van is self-powered. We only need a flat surface and room to lift the car.
How much does mobile tyre service cost in Dubai?
Call-out with a puncture repair is AED 99–149. New tyres include fitting and balancing in the tyre price.
Can you work in an underground car park?
Usually, yes. Tell us the clearance height and whether a gate pass is needed.
